According to the change log of the newest franco kernel version r391, the modules support was enabled and Touch Control should work. However after I updated the kernel, the PGM2 still couldn't work. Load modules failed.
my device is Galaxy Nexus 4.3
and here's the change log of franco r391:
* Add fsync toggle back
* Disable Smartreflex calibration which would cause some frequency steps to be overcalibrated wrongly and causing overheat
* Enable modules support so Touch Control will work again
* Properly set up Timer Slack
here report bugs for TouchControl/PGM
2 posts • Page 1 of 1
I'll take a look at it and try to release new version soon.