Page 1 of 1

pgm doesn't work with franco r391which enabled modules

Posted: Tue Aug 27, 2013 12:18 am
by naiqus
According to the change log of the newest franco kernel version r391, the modules support was enabled and Touch Control should work. However after I updated the kernel, the PGM2 still couldn't work. Load modules failed.

my device is Galaxy Nexus 4.3

and here's the change log of franco r391:
r391:
* Add fsync toggle back
* Disable Smartreflex calibration which would cause some frequency steps to be overcalibrated wrongly and causing overheat
* Enable modules support so Touch Control will work again
* Properly set up Timer Slack

Re: pgm doesn't work with franco r391which enabled modules

Posted: Tue Aug 27, 2013 11:52 am
by ponury
I'll take a look at it and try to release new version soon.